Flamant BulleExterior cleaning

Pressure washing

Pressure is a tool, not a reflex. Concrete can take it, wood much less, and paver joints not at all.

Request an estimate →

Pressure washing suits hard mineral surfaces such as concrete. Pressure and nozzle must still be matched to each surface: low pressure and a wide spray for wood, extreme care on interlocking pavers so the polymeric sand stays in the joints, and never high pressure on an asphalt shingle roof.

The right pressure for each surface

Consumer guides all point the same way, even if the numbers vary:

  • Concrete: the toughest surface, cleaned efficiently at around 2,500 to 3,000 psi.
  • Wood: low pressure and a wide nozzle, along the grain, so the fibres don't lift.
  • Brick: very moderate pressure, since the joints are fragile.

These ranges are only indicative. On site, we always start with the lowest pressure that works and test in an inconspicuous spot.

Interlocking pavers: protect the polymeric sand

Permacon, a Quebec paver manufacturer, does not recommend pressure washers except in the hands of a qualified, experienced professional: a spray angled at about 30 degrees and perpendicular to the joints, so the polymeric sand isn't dislodged.

If the joints are damaged, Permacon advises removing at least 1½ inches (38 mm) of old sand before adding new sand, in summer, within the manufacturer's temperature range. A sealer only goes on perfectly dry sand.

The nozzle colour code

Nozzles are identified by colour: red (0°), never to be used close to any surface; yellow (15°); green (25°), good for masonry; white (40°), for general washing; black (65°), for applying soap. The wider the angle, the gentler the spray.

Your town may regulate driveway washing

Many municipalities restrict the use of drinking water to wash a driveway, patio or wall. In Montreal, for example, it is allowed from April 1 to May 15 or after work that justifies it; in Quebec City, spring cleaning of driveways is allowed from April 1 to June 15. Each city page on this site gives the local rule once it has been checked in the official text.

How we do it

  • We work with a pressure washer.
  • On flat surfaces such as pavers and concrete, we use a rotary surface cleaner for an even, streak-free result.
  • We work on buildings up to 4 storeys.

Frequently asked questions

Can interlocking pavers be pressure washed? +

Yes, but only with care: an angled spray perpendicular to the joints, so the polymeric sand isn't dislodged. The manufacturer Permacon reserves it for experienced professionals.

What pressure for a wood deck? +

Low pressure and a wide nozzle, along the grain. Too much pressure lifts the wood fibres.

Do you pressure wash roofs? +

No. An asphalt shingle roof is cleaned by soft washing, at low pressure. High pressure strips the granules.

Am I allowed to wash my driveway? +

It depends on your town and the time of year. Many municipalities regulate driveway washing with drinking water. Check your city's page.

Sources

By Scott Lanthier, President · reviewed on November 21, 2026