Interlocking pavers can be pressure washed, but with a spray angled at about 30 degrees and perpendicular to the joints, so the polymeric sand isn't dislodged. If the joints are damaged, at least 1½ inches of old sand are removed before adding new sand, in summer. A sealer only goes on perfectly dry sand.
Why the joints are the weak point
Polymeric sand hardens between the pavers and stabilizes them. A spray that is too direct digs it out, and a hollow joint lets weeds grow and pavers shift. Protégez-Vous advises homeowners against pressure washers for this reason.
The method recommended by the manufacturer
Permacon, a Quebec paver manufacturer, only recommends pressure in the hands of an experienced professional, with two rules:
- a spray angled at about 30 degrees;
- a spray perpendicular to the joints, never along them.
When to re-sand
If cleaning reveals hollow or crumbling joints, Permacon advises removing at least 1½ inches (38 mm) of old sand before adding new sand, in summer, respecting the minimum temperatures given by the sand manufacturer. The sand must then dry completely to stay cohesive.
And sealer?
A sealer makes later maintenance easier, but it only goes on perfectly dry sand: moisture limits its penetration. It doesn't need to be reapplied every year.
Check your town before washing
Many municipalities regulate driveway washing with drinking water. Mascouche, for example, prohibits driveway washing from May 1 to September 30, but provides a temporary permit for cleaning pavers before applying polymeric sand. See our summary of municipal bylaws.
Frequently asked questions
Does the sand need redoing after a wash? +
Only if the joints were dug out or were already damaged. A proper wash, angled and perpendicular to the joints, preserves them.
Can I seal right after washing? +
No, wait until the sand is perfectly dry.